Chemicalssyngentaaprovia

Aprovia

Syngenta · EPA Reg 100-1471 · Fungicide Document last checked 2026-05-30

About this product

Active ingredient Pending extraction
Manufacturer Syngenta
Category Fungicide

Full details for Aprovia

Source product label ↗ Open the catalog source label while the local copy is reviewed. Verify the product name, EPA registration number, and revision before use. Source safety data sheet ↗ Open the catalog source SDS while the local copy is reviewed. Verify the exact product and revision before relying on it. EPA registration data Reg. 100-1471 — registry reference, signal word and status.

Applicator discussion

Nothing here is label direction — the label is the law. These are notes from other applicators, moderated before they appear. Check the labeling accompanying the product and applicable state requirements.

Add your experience

Sign in through the portal or Create a free account to post. Comments are reviewed before they appear. Need a website for your pest-control business? See site plans.

According to the label From the product label

These details were extracted from this product's label PDF. The label is the law. Confirm every rate, site, restriction and safety requirement against the label before mixing or applying. Check for a state supplemental label; a product may be restricted or prohibited in a state or site even when a rate appears below. · EPA registration data for Reg. 100-1471 →

Aprovia is a broad-spectrum fungicide manufactured by Syngenta, used for the control of many important plant diseases. The active ingredient is Benzovindiflupyr (9.63%), formulated as an Emertible Concentrate (EC) containing 0.63 lb of benzovindiflupyr per gallon. It is primarily applied as a foliar spray and can be used in block, alternating spray, or tank-mix programs with other crop protection products. This product is suitable for various crops, including blueberries, grapes, small fruit vine climbing crops (subgroup 13-07F, except fuzzy kiwi fruit), and Pome Fruit Group 11-10. Application methods include ground and aerial sprays, as well as chemigation. When using this product, handlers must wear specific Personal Protective Equipment (PPE), including protective eyewear (goggles, face shield, or safety glasses), coveralls worn over short-sleeved shirts and short pants, chemical-resistant footwear plus socks, and chemical-resistant gloves (butyl rubber or nitrile rubber). A chemical-resistant apron is required when cleaning, mixing, or loading. Users should be aware of environmental hazards; do not apply directly to water or areas where surface water is present or to intertidal areas below the mean high water mark. To prevent runoff, maintain a 15-foot vegetated buffer strip between treated areas and surface water features like ponds or streams. Always follow the Worker Protection Standard (WPS) and observe the 12-hour restricted-entry interval (REI) after application.

Pests covered (1)
many important plant diseases
Areas treatable (1)
foliar spray

Application instructions from the label 1

foliar spray

Can be used in block, alternating spray, or tank-mix programs.

Target pest
many important plant diseases
Location
Outdoor

Mixing instructions 1

Label notes
Can be used in tank-mix programs with other crop protection products.

Worker safety

Re-entry interval (REI) 12
PPE required Protective eyewear (goggles, face shield, or safety glasses); Coveralls worn over short-sleeved shirt and short pants; Chemical-resistant footwear plus socks; Chemical-resistant gloves (butyl rubber or nitrile rubber); Chemical-resistant apron when cleaning, mixing or loading.

Timing & weather

Use restrictions 4